Free shipping on orders over $15

Shopping Cart

  • No products in the cart.

SpeedyBee F405 WING APP Fixed Wing Flight Controller – SB-02-02

$51.27 $25.64

  • Shipping Icon
    Free
    Shipping
  • Shipping Icon
    Safe
    Payment
  • Shipping Icon
    Best
    Services
Categories :
  • Lighting & Studio
  • Specification

    Product Name SpeedyBee F405 WING FC board
    MCU STM32F405,168MHz,1MB Flash
    IMU(Gyro&Accelerometer) ICM-42688-P
    Barometer SPL006-001
    OSD Chip AT7456E
    Blackbox MicroSD Card Slot
    UART 6 sets(USART1, USART2, USART3, UART4, UART5, UART6(Dedicated for Wireless board Telemetry connection))
    I2C 1x Used for magnetometer, digital airspeed sensor
    ADC 4x (VBAT, Current, RSSI, Analog AirSpeed)
    PWM 12x (11+1LEDpad)
    ELRS/CRSF receiver Supported,connected to UART1
    SBUS Built in inverter for SBUS input (UART2-RX)
    LED 3x LEDs for FC STATUS (Blue, Green) and 3.3V indicator(Red) 1x RGB
    RSSI Supported,Named as RS .
    Supported FC Firmware INAV:SpeedyBeeF405WING(default)ArduPilot: SpeedyBeeF405WING
    Weight 8.9g
    Product Name SpeedyBee F405 WING PDB board
    Input voltage range 7~36V (2~6S LiPo)
    Battery Voltage Sensor Connect to FC board VBAT, 1K:10K (Scale 1100 in iNav, BATT_VOLT_MULT 11.0 in ArduPilot)
    Battery Current Sensor 90A continuous, 215A peak Connect to FC board Current (Scale 195 in iNav, 50 A/V in ArduPilot)
    TVS Protective diode Yes
    FC BEC output Output 5.2V +/- 0.1V DC Continuous current 2.4 Amps, 3A Peak Designed for FC, Receiver, GPS module, AirSpeed module, Telemetry module, WS2812 LED_Strip
    VTX BEC output Output 9V +/- 0.1V DC Continuous current 1.8 Amps, 2.3A Peak Voltage adjustable, 9V Default, 12V or 5V via jumper Designed for Analog Video Transmitter,Digital Video Transmitter, Camera.
    Servo BEC output Output 4.9V +/- 0.1V DC Continuous current 4.5 Amps, 5.5A Peak Voltage adjustable, 4.9V Default, 6V or 7.2V via jumper Designed for Servos.
    Weight 11.4g
    Product Name SpeedyBee F405 WING Wireless board
    Wireless Configuration (long press BOOT button for 6 seconds to switch modes) BLE mode, connect to Speedybee APP
    W

    Add a Review

    Your email address will not be published. Required fields are marked *