SpeedyBee F405 V5 30×30 Flight Controller

Specifications

• MCU STM32F405
• IMU (Gyro) ICM42688P
• USB Port Type New Type-C interface
• Barometer SPA06-003
• OSD Chip AT7456E
• Full-featured Bluetooth Tuning Supported. Connect via SpeedyBee App for FC firmware flashing and parameter tuning.
• Wireless FC Firmware Upgrade Supported
• DJI Air Unit Connection Supports 6-pin direct plug-in or solder connection
• Blackbox Supported, built-in 16MB storage chip
• Input Voltage 3-6S LiPo battery
• Independent 5V BEC Output 9 groups (4 +5V pads on front, 1 BZ+ buzzer pad, and 4 +5V pads at the corners for external LEDs). Total output current: 1.5A.
• Independent 9V BEC Output 2 groups (1x 9V pad on front, 1x 9V output in a connector on the back). Total output current: 3A. Supports PINIO remote on/off control.
• MCU & Gyro Power Independent LDO
• 3.3V Output 1 group (1 3.3V pad on front)
• 4.5V Output 3 groups (3 4.5V pads on front). Can power receiver and GPS when FC is powered via USB. Max output current: 1A.
• ESC Signal M1-M4 pads and 10-pin connector on the back
• Servo Signal S5-S6 pads on the front
• ESC Telemetry Input Supported (UART5)
• Betaflight Camera Tuning Pad Supported (CC pad on front)
• I2C Supported (GPS connector + pads)
• UART UART1 (Bluetooth); UART2 (front pads for receiver); UART3 (DJI VTX pads + rear SH1.0-6-pin); UART4 (GPS pads + front SH1.0-6-pin); UART5 (TLM); UART6 (receiver pads + rear SH1.0-4-pin)
• ST LED Pads Supported, on front G/5V/LED pads; controlled by FC firmware
• Meteor LED Strip Pads Supported. Switch between SB-LED and ST-LED modes via BOOT button or App. In SB-LED mode, controlled by ESP32 Bluetooth chip.
• Buzzer Pads Supported
• BOOT Button [A] Hold BOOT while powering on to force DFU mode for flashing.
• [B] When powered and in standby, short-press cycles LED display modes; long-press switches SB-LED/ST-LED. In ST-LED mode, LED1LED4 are controlled by FC firmware.
• RSSI Pads Supported
• SmartPort Not supported
• Supported FC Firmware Betaflight, INAV, Ardupilot
• Firmware Target Name SPEEDYBEEF405V5
• Factory Firmware Version Betaflight 4.5.2
• Configurator Version Betaflight 10.10.0
• Mounting Holes 30.5 30.5mm (4mm), side opening
• Dimensions 39mm (L) 39mm (W) 4.9mm (H)
• Weight 8.1g

Manual