Free shipping on orders over $15

Shopping Cart

  • No products in the cart.

SpeedyBee F405 V4 BLS 55A 30×30 FC&ESC Stack – SB-02-04

$89.73 $44.87

  • Shipping Icon
    Free
    Shipping
  • Shipping Icon
    Safe
    Payment
  • Shipping Icon
    Best
    Services
Categories :
  • Lighting & Studio
  • Specifications

    <

    Add a Review

    Your email address will not be published. Required fields are marked *

    Product Name SpeedyBee F405 V4 30×30 Flight Controller
    MCU STM32F405
    IMU(Gyro) ICM42688P
    USB Port Type Type-C
    Barometer Built-in
    OSD Chip AT7456E chip
    BLE Bluetooth Supported. Used for Flight Controller configuration(MSP should be enabled with Baud rate 115200 on UART4)
    WIFI Not supported
    DJI Air Unit Connection Way Two ways supported: 6-pin connector or direct soldering.
    6-pin DJI Air Unit Plug Supported. Completely compatible with DJI O3/RunCam Link/Caddx Vista/DJI Air Unit V1, no wire is needed to be changed.
    Blackbox MicroSD Card Slot *Betaflight firmware requires the type of the microSD card to be either Standard (SDSC) or High capacity (SDHC) under 32GB, so extended capacity cards (SDXC) are not supported(Many high-speed U3 cards are SDXC). Also the microSD card MUST be formatted with the FAT16 or FAT32 (recommended) format, you could use any SD card less than 32GB, but the Betaflight can only recognize 4GB maximum. We suggest you use this3rd party formatting tooland choose ‘Overwrite format’ then format your card. Also check outherefor the recommended SD cards or buy thetested cardsfrom our store.
    Current Sensor Input Supported. For SpeedyBee BLS 55A ESC, please set scale = 400 and Offset = 0.
    Power Input 3S – 6S Lipo(Through G, BAT pins/pads from the 8-pin connector or 8-pads on the bottom side)
    5V Output 9 groups of 5V output, four +5V pads and 1 BZ+ pad( used for Buzzer) on front side, and 4x LED 5V pads. The total current load is 3A.
    9V Output 2 groups of 9V output, one +9V pad on front side and other included in a connector on bottom side. The total current load is 3A.
    3.3V Output Supported. Designed for 3.3V-input receivers. Up to 500mA current load.
    4.5V Output Supported. Designed for receiver and GPS module even when the FC is powered through the USB port. Up to 1A current load.