Free shipping on orders over $15

Shopping Cart

  • No products in the cart.

RESOL DeltaSol BS/4 to suit Dux Solar Systems (1-2 sensors) – Replaced by DeltaSol SLL

$269.74 $134.87

  • Shipping Icon
    Free
    Shipping
  • Shipping Icon
    Safe
    Payment
  • Shipping Icon
    Best
    Services

Identifying your controller

The RESOL DeltaSol BS/4 was the differential temperature controller fitted to DUX AusCaps solar hot water systems in Australia, in its 12 sensor configuration. If your controller is labelled DeltaSol BS/4 and came with a DUX AusCaps system, this is your original part.

The RESOL DeltaSol BS/4 is no longer manufactured. The current direct replacement is the RESOL DeltaSol SLL, described below.

The RESOL DeltaSol SLL is the current replacement controller for the RESOL DeltaSol BS/4, BS/2, BS Plus, AX and AL. It is the smallest controller in the SL series, optimised for small and medium-sized solar thermal systems, with 2 pre-configured basic systems available. It offers automatic function control to the VDI 2169 directive and a V40 flowmeter input for heat quantity measurement. The tube collector function makes it suitable for both flat plate and evacuated tube collectors.

The DeltaSol SLL supplied in Australia is a market-specific version, confirmed by RESOL. It does not include a thermal disinfection function, an SD card slot, or VBus RPT remote parameterisation. If your existing controller uses any of these, please contact us before ordering.

RESOL DeltaSol SLL Specification

  • Relay outputs: 2 semiconductor relays, 1 A each, 2 A total at 240 V
  • Sensor inputs: 4, for Pt1000, Pt500 or KTY sensors
  • Flow input: 1 x V40 impulse input for heat quantity measurement
  • PWM outputs: 2, for high-efficiency pump speed control
  • System layouts: 2 pre-configured
  • Function control: automatic, to VDI 2169
  • Tube collector function: yes suits evacuated tube and flat plate
  • Thermostat function: yes
  • Data interface: VBus
  • Power supply: 100240 V, 5060 Hz
  • Ingress protection: IP 20 indoor, dry location only
  • Ambient temperature: 0 to 40 C
  • Dimensions: 110 x 166 x 47 mm. Mounting centres 130 mm

What you receive: the RESOL DeltaSol SLL 1-2 sensor controller, supplied with two new sensors one 20m roof sensor and one tank sensor. New sensors are always supplied with a replacement controller and must be fitted at the same time. Reusing existing sensors with a new controller voids warranty.


Manual & Documentation

Download the RESOL DeltaSol BS/4 Manual (PDF)

Add a Review

Your email address will not be published. Required fields are marked *