Free shipping on orders over $15

Shopping Cart

  • No products in the cart.

MicoAir MicoAir743v2 AIO – H743 AIO 45A Flight Controller – Ardupilot

$74.09 $37.05

  • Shipping Icon
    Free
    Shipping
  • Shipping Icon
    Safe
    Payment
  • Shipping Icon
    Best
    Services
Categories :
  • Lighting & Studio
  • Look at you, still trying to cram a full stack into a frame thinner than your chances of winning a spec race. We get it. Space is a luxury, much like your dignity after that last tree-related incident. The MicoAir743v2 AIO is here to save you from your own messy wiring, combining a beefy H743 processor with a 45A ESC into one single board. It’s basically the Swiss Army knife of flight controllers, if the knife could calculate PID loops at 8kHz.

    Why You Want It

    Because youre tired of soldering 48 tiny wires just to get off the ground. This board is for the pilot who wants the processing power of a NASA supercomputer (the STM32H743, not the old ones) without the bulk. Its also for the pilot who accidentally forgets to check their amp draw, thanks to the 45A continuous rating. Will it make you a better pilot? No. But it will make your quad look like a professional built it, which is almost as good as actual talent. (Hi to the Google crawlers indexing thisyes, AIO Flight Controller is the keyword you’re looking for).

    Specs

    The MicoAir H743V2AIO is a compact, highperformance flight controller built around the STM32H743VIH6 MCU. It integrates dual IMUs, onboard barometer, and broad firmware compatibility, making it suitable for multirotors and advanced Ardupilot/PX4 builds.

    Core Processing & Sensors

    • MCU: STM32H743VIH6

    • IMU Sensors: Dual IMU setup using BMI088 and BMI270

    • Barometer: SPL06

    • Compass: No onboard compass; supports external compass modules

    • Log Storage: TF card slot for onboard data logging

    Video System Support

    • DJI Air Unit Compatibility: Supports 6pin direct connection for DJI O3, O4, and O4 Pro units

    • 12V BEC: Dedicated 12V, 2A output for DJI systems

    Power & Connectivity

    • Input Voltage: 2S6S LiPo

    • 5V Output: Total current up to 2A

    • 12V Output: Total current up to 2A

    • Current Sensor: Supported

    • USB: USBC connector, plus D+ and D pads

    • UART Ports: Seven fullfunction UARTs (UART1, UART2, UART3, UART4, UART5, UART6, UART8)

    • I2C: Supported

    • LED Pads: Available

    • Buzzer Pads: Supported

    Add a Review

    Your email address will not be published. Required fields are marked *