Free shipping on orders over $15

Shopping Cart

  • No products in the cart.

Holybro Tekko32 F4 50A 4in1 ESC

$57.65 $28.83

  • Shipping Icon
    Free
    Shipping
  • Shipping Icon
    Safe
    Payment
  • Shipping Icon
    Best
    Services
Categories :
  • Drones & RC
  • Holybro Tekko32 F4 4in1 50A ESC (30×30)

    Looking to buy the Holybro Tekko32 F4 4in1 50A ESC in the UK? Since BLHeli_32 folded, open-source 32-bit speed has found its true home. This 30×30 4in1 ESC pairs a screaming 150MHz F4 MCU with native AM32 firmware to wipe out motor desyncs and throttle delay on 4S to 6S quadcopters. Supporting variable 16kHz96kHz PWM frequencies and DShot1200 protocol execution, it keeps your Betaflight PID loop clean without overloading processor cycles. Backed by our 10 years of experience in the manufacturing and delivery of commercial FPV systems at Unmanned Tech, we bring you battle-tested hardware built to survive hard crashes while keeping the magic smoke safely trapped inside your MOSFETs.

    Key Highlights

    • 150MHz F4 Processing Power: Drastically outperforms legacy F3 (108MHz) and F0 (48MHz) MCUs for ultra-fast motor response and zero control lag.
    • Native AM32 Open-Source Firmware: Pre-flashed with target AM32_TEKKO32_4IN1_F421; adjust settings easily via the AM32 portal or directly using the web-based AM32 configurator.
    • Galvanic Isolation Architecture: Features separate drive and control circuits, expanding current-handling headroom while shielding sensitive logic lines from high-voltage motor electrical interference.

    Why You Want It

    If you’ve spent one too many late nights nursing a soldering iron burn while staring blankly at Betaflight motor tabs trying to hunt down mid-throttle oscillations, the Tekko32 F4 is your ticket off the pain train. Holybro built this 30.5×30.5mm stack unit with physical separation between its high-power drive circuits and delicate logic controller. Pushing up to 96kHz PWM output, it makes your motors run noticeably smoother, cooler, and quieter across aggressive 6S freestyle flips and race gates. With a rating of 50A continuous (60A burst per channel), native telemetry, and an onboard analog current sensor, your OSD readout stays accurate down to the final battery cell drop.

    Specifications

    • Continuous Current: 50A 4
    • Burst Current: 60A 4
    • Input Voltage: 46S LiPo
    • MCU: F4 MCU @ 150MHz
    • PWM Frequency Range: 16kHz to 96kHz
    • Firmware Target: AM32_TEKKO32_4IN1_F421
    • Supported Protocols: DShot 150/300/600/1200, MultiShot, OneShot, Proshot, PWM
    • Current Sensor: Onboard analog (Scale ratio: 120 – V1.9 Version)
    • ESC Telemetry: Supported
    • BEC Output:
    Add a Review

    Your email address will not be published. Required fields are marked *