The Happymodel Mobula6 Race HD BNF is the first 65mm HD brushless tiny whoop that weighs less than 19.4g. With tiny whoops, every gram makes a large difference in flight performance. To achieve such a low weight, HDZero has developed the worlds first 5-in-1 AIO that contains a HDZero VTX, FC, ESC, ELRS RX, and 5V1A BEC. Using a single thick PCB rather than a stack of 2 improves durability and simplicity get ready for a new era of no-compromise tiny whooping in clear digital video!

To keep weight and cost to a minimum, the Race HD BNF features the light weight HDZero Eco camera. The camera outputs HD composite video (720p) via a single wire instead of a MIPI cable, reducing footprint, cost, and increasing durability. The digital video signal has stable color reproduction and 720p progressive scan video with the stable near-zero latency HDZero is known for.

In order to achieve the goal of extreme weight reduction, HAPPYMODEL used original Japanese RENY screws at all costs, and also designed a lighter 5.8G VTX antenna. All these improvements are to make this HD BNF weigh less than 20 grams. We hope you like it.

Binding procedure:

Specifications

• Weight: 19.3g
• Recommended Battery: 1S 300mAh
• Propeller Size: 31mm
• Flight time: around 2.5~3 minutes
• Factory SKU: 5A10094

AIO Flight controller

• MCU: STM32F411 (100MHz, 512K Flash)
• Gyro: BMI270
• On board voltage and amperage meters
• Built-in 5A(each) BLHeli_S 4-in-1 ESC
• Built-in 5.8G HDZero VTX
• Built-in SPI ExpressLRS 2.4GHz receiver
• Built-in 5V 1A BEC
• Board size:28.528.5mm with a 25.525.5 mounting hole size
• Firmware target: CRAZYBEEF4SX1280

HDZero Eco Camera

• Sensor size: 1/3 inch
• Resolution: 720p60 4:3
• FOV: D:150 H:120 V:98

Motors

• Kv:28000
• Stator diameter: 7mm
• Stator length:2mm
• Shaft diameter: 1mm
• Weight:1.5g

Included

• 1x Happymodel Mobula6 Race HD BNF
• 1x Spare canopy
• 1x Spare propeller(set)
• 1x Screw driver
• 1x propeller disassemble tool

Default port and receiver settings: