Free shipping on orders over $15

Shopping Cart

  • No products in the cart.

BetaFPV Toothpick 20A F411 4S AIO Flight Controller V5

$54.15 $27.08

  • Shipping Icon
    Free
    Shipping
  • Shipping Icon
    Safe
    Payment
  • Shipping Icon
    Best
    Services

Key Features

  • With a large pad to solder, it is easy to solder external electronics. In addition, the V5 board features plug&play ports for the receiver and HD digital VTX, which requires less solder work for convenient installation.
  • High-quality MOSFETs are applied to F411 4S 20A FC V5 to handle 20A continuous current and reach 25A peak current.
  • The motor solder pads are reinforced by thick copper and edge plating technology, allowing lower resistance for more current on motors.
  • F411 4S 20A FC V5 reserves the UART ports layout, UART1 for RX, UART2 for DJI OSD or Analog VTX, and UART6 for spare usage, more convenient for pilots to solder.
  • Come with a 25.5*25.5mm whoop mounting pattern, this board can be added to both the toothpick drone and the cinematic whoop quadcopter frame like Pavo25 and X-knight 35 .

Flight Controller Specifications

  • CPU: STM32F411CEU6 (100MHZ)
  • Six-Axis: BMI270 (SPI connection)
  • Mounting Size: 25.5*25.5mm (M2 Anti-vibration rubber damper available)
  • FC Firmware: betaflight_4.3.x_BETAFPVF411
  • OSD: Built-in Betaflight OSD (OSD chip: AT7456E)
  • Receiver: SBUS/CRSF/DSMX Receiver
  • BEC: 5V 3A
  • Built-in current sensor
  • Weight: 8.15g

ESC Specifications

  • ESC Chip: SILABS EFM8BB21F16G-C
  • Support D-shot150, D-shot300, D-shot600, Oneshot125, Multishot, PWM
  • Input voltage: 2S-4S Lipo
  • Continuous current: 20A
  • Peak current: 25A
  • Firmware: G_H_20_REV16_7.HEX (Default BLHeli_S), BLUEJAY (Optional)

Note: F411 4S 20A FC V5 is available to flash both BLHeli_S and BLUEJAY ESC firmware and it comes with default BLHeliI_S firmware. The main difference is that the BLUEJAY firmware supports bidirectional D-shot, while BLHeli_S does not support it.

Toothpick 20A F411 4S AIO V5 Pinout

Comparison to F411 4S 20A V3 FC

We upgraded the F411 4S 20A V3 board to V5 by adopting BMI270 gyro instead of MPU6000 and adding some new features. BMI270 gyro works great in most cases, especially in low frequency. Unlike the V3 board that supports JST1.25 connectors, the motor solder pads on V5 board are solderable only and reinforced by thick copper and edge plating

Add a Review

Your email address will not be published. Required fields are marked *