Free shipping on orders over $15

Shopping Cart

  • No products in the cart.

BetaFPV F4 1S 12A AIO Brushless Flight Controller 2022

$56.22 $28.11

  • Shipping Icon
    Free
    Shipping
  • Shipping Icon
    Safe
    Payment
  • Shipping Icon
    Best
    Services

F4 1S 12A AIO Brushless Flight Controller 2022 is the default FC for Cetus X brushless whoop quadcopter, also great for 85mm whoop drones like Meteor85 and 3″ toothpick drones. We updated the FC to V2.2 with BMI270 gyro and BB51 ESC hardware in place of ICM20689 gyro and BB21 ESC hardware.

Features

  • F4 1S 12A AIO Flight Controller is the best choice for building ultra-lightweight 3″ toothpick drones like HX115 SE FPV Quad and 85mm whoop drones. Recommend Meteor85.
  • Most of the 1S flight controllers on the market come with 5A ESC by now, but this FC especially integrates 1S 12A ESC, providing more sufficient power for 3″ toothpick drones or 85mm whoop drones.
  • Built-in current meter, 2 programmable RGB LEDs, and SPI ELRS or Frsky receiver. At the same time, all the pads are left for the external receivers with UART1 and UART2, for buzzers, etc.
  • Large pads are reserved for solder motor cables, this design will make solder easier.

Specification of FC

  • Item: F4 1S 12A AIO FC
  • Weight: 4.74 g (without power cable and BT2.0 connector)
  • CPU: STM32F411CEU6 (100MHZ )
  • Six-Axis: BMI270 (SPI connection)
  • Firmware version: betaflight_4.3.1_BETAFPVF4SX1280
  • OSD: Built-in BetaFlight OSD (STM32 controls OSD chip over SPI in DMA mode)
  • Receiver: SPI ELRS 2.4G Receiver
  • Motor Pin Connector: 1.25mm Header Pins
  • Mounting Hole Size: 26mm x 26mm (suitable for whoop pattern mounting hole)
  • USB Port: SH1.0 4-Pin

Specification of 1S 12A ESC

  • Built-in ESC with 12A continuous and peak 25A current
  • Input voltage: 1S-2S
  • ESC firmware: C_X_30_REV16_7.hex for BB51 BLHeli_S hardware
  • Signal support: D-shot150, D- shot300, D-shot600, Oneshot125, Multishot, PWM

This new BLHeli_S firmware (named C_X_30_REV16_7.hex) is supported by BLHeli Configurator, BLHeliSuite, and Bluejay Configurator.

Diagram for F4 1S 12A AIO FC

Below is the diagram for the SPI Frsky version board. UART1, UART2, and SBUS pads are left for external receivers like Frsky XM+, TBS Nano receiver so that a long receiver range is available.

Buzz pads (BUZZ+ and BUZZ-) are invalid directly. It needs some modification to make it works.

ELRS Version Pinout

Add a Review

Your email address will not be published. Required fields are marked *